(11) 2088-5701
DRYKOTEC 5500
18 kg
Waterproofing with high content of polymeric resin and cements with active loads, forming after curing, an elastic and flexible layer, which accompanies the workability of the structure. This system has the advantage of resisting positive pressure, in addition to being applied cold.
Suitable for: areas subject to constant structural movements such as swimming pools, reservoirs, elevator shafts, terraces, balconies, kitchens, service areas, bathrooms, water mirrors.
Perform regularization with a minimum drop of 1% towards the water drainage points, prepared with cement mortar and medium sand 1: 4 trace, adding DRYKOFIX CHAPISCO adhesive emulsion in the mixing water for greater adhesion on the substrate. It is worth mentioning that no type of water repellent should be placed in the regularization mortar.
The mortar must be finished with a minimum thickness of 2 cm. The surface must be moistened with water before applying the product. In the event of percolation or spurts of water from the water table, buffering must be performed before applying DRYKOTEC 1100. Before applying DRYKOTEC 1100 in swimming pools or in buried concrete reservoirs, perform a water load test for at least 72 hours for accommodation of the structure, checking for possible appearance of cracks and cracks that can occur in the total load.
Mix the DRYKOTEC 5500 for 5 minutes, components A and B until a homogeneous paste is formed. Mix the product manually every 15 minutes.
Mix components A and B for 5 minutes, until a homogeneous paste is formed. Mix the product manually every 15 minutes.
Apply with a soft broom, brush or brush. Moisten the surface well and apply 3 to 4 coats of the mixture in crossed directions, allowing to dry at least 4 hours before the next coat.
In critical areas, such as reservoir bottoms and cold joints, drains and pipes, a 2 × 2 mm mesh polyester industrial screen must be incorporated after the first coat. When applied to an area exposed to the sun, it must be hydrated for 3 consecutive days.
In tanks, reservoirs and any other areas that will be in permanent contact with water, the surface of the product must be cleaned, washing with water and neutral soap and rinsing with plenty to remove all soap.
There should be no product accumulated in the corners / corners of the waterproofed area, this excess can cause cracks. The application must be transferred to eliminate the excess. We recommend the use of mechanical protection mortar on the floor for application in water tanks, due to the cleaning services that will be performed in the future.
For laying the final coating, we recommend AC-III glue cement.
DRYKOTEC 5500 cannot be used in places with a pH below 6.
Wait 96 hours after applying the last coat before doing the tightness test.
Validity of the product is 12 months from the date of manufacture, provided that it is stored in an upright position, in its original and intact packaging, in a dry, well-ventilated place and away from heat under a maximum temperature of 30 ºC.
We guarantee the quality of our products against manufacturing defects. We do not assume responsibility for the poor performance of the work due to incorrect use and because we do not have direct control over the application. The product must be applied by a qualified professional and in accordance with the instructions in our technical bulletin and in the Product Safety Data Sheet.
We recommend observing the safety rules established by the competent bodies and the use of suitable PPE such as gloves and safety glasses.
In poorly ventilated environments, promote forced ventilation.
The product should not be ingested or come into contact with the skin or eyes.
In case of accidental ingestion, do not force vomit. In contact with eyes, rinse well with water for an average of 10 to 15 minutes. In contact with the skin, wash well with soap and water and use moisturizer. Do not remove the product. Search for a doctor.
Keep out of reach of children and animals.
Not suitable for application in closed places, if necessary to create forced ventilation.
