DRYKOPOXI
1 kilo

Homogenize the two components separately. Then add component B to component A and mix for at least 3 minutes until a homogeneous gray material is obtained.

Apply the product with a brush or spatula, filling the entire surface, ensuring a thickness of approximately 2mm.

The material to be glued must contact the DRYKOPOXY within 2 hours, in its sticky state.

For anchors, the DRYKOPOXY must be poured into the hole so that it overflows a little after the bar is inserted. The piece to be set must be placed slowly and with light circular movements.

Do not move the bar until DRYKOPOXY is completely dry, which may vary according to the ambient temperature.

Validity of 12 months from the date of manufacture.

The product must be stored in a covered, ventilated, dry place, away from heat sources.

We guarantee the quality of our products against manufacturing defects. We do not assume responsibility for misuse.

We recommend observing the safety rules established by the competent sectors and the use of suitable PPE such as gloves and safety glasses.

The product should not be ingested or come into contact with the skin or eyes.

In case of accidental ingestion, do not force vomit. In contact with eyes, rinse well with water for an average of 10 to 15 minutes. In contact with the skin, wash well with soap and water and use moisturizer. If the problem persists, seek medical attention.

Keep out of reach of children and animals.