DRYKOPUR LAJE
4,2 Kg

Mix components A and B separately for approximately 2 minutes, gradually add component B to component A and continue mixing for approximately 3 to 5 minutes.

Before preparing the product, make sure that the application substrate is dry and with humidity below 5%, perform a test with a 1 x 1 meter plastic film glued with adhesive tape, waiting for 3 hours, if there is condensation, the product cannot be applied , remove the plastic and wait for drying.

Packing
Set: 4.2 kg
Component A: 3.50 kg
Component B: 0.70 kg

Apply the product with the help of a brush and wool roller and in a thin layer and wait for drying for 6 to 8 hours, applied at a temperature of 25˚C and relative humidity at 50%. Before starting the second coat, support DRYKOTELA and apply the following coats until reaching the recommended consumption and full coverage of DRYKOTELA.

Pay attention to the application of the next coat when the previous layer still shows light stickiness, if it has dried for more than 24 hours and does not show light stickiness, you should perform surface sanding to open the porosity.

Curing time and pot life of the product may vary according to the ambient temperature and relative humidity. Mix the product during application to avoid formation of superficial skin.

In places that require adherence of the coating or mechanical protection mortar directly on the product (places without thermal movement, internal areas), you should spray dry sand on the last coat of the product that is still wet.

Mechanical protection
Ceramic coating
After drying the product, adhere the ceramic coating with adhesive mortar ACIII, taking care not to damage the waterproofing product.

Mortar
When necessary, we recommend performing mechanical protection using a 1: 3 line with DRYKOFIX in the mixing water, with a minimum thickness of 3 cm.
In reservoirs, we recommend performing mechanical protection on the floor to protect the waterproofing during washing services.

Color
Grey

Consumption
1,20 kg / m²

Cleaning
The cleaning of tools and equipment can be carried out with polyurethane solvent before drying the product, after drying the removal must be carried out mechanically.

Valid for 12 months from the date of manufacture as long as the storage standards are respected.

Store in a covered, dry, ventilated place and away from heat sources, in environments with temperatures not exceeding 30° C and in an upright position.

• Handle with care. Avoid strong shocks and contact with sharp surfaces.
• We recommend observing the safety rules established by Organs competent bodies and the use of appropriate PPE.
• The product should not be ingested or come into contact with the skin or eyes.
• In case of accidental ingestion, do not force vomit. In contact with eyes, rinse thoroughly with water for at least 15 minutes. In contact with the skin, wash well with soap and water and use moisturizer. Do not remove the product. Search for a doctor.
• Keep out of reach of children and animals.
• Indoors, if necessary, create forced ventilation.
• For more information on handling and safety, consult the product MSDS, available on our website
• Dispose of the contents / container to an approved treatment and disposal facility. Do not reuse the packaging.

• Flexible and elastic;
• Low VOC (volatile active compounds);
• Solvent-free for indoor applications;
• Waterproof with low consumption.